If you are using a Boca Lemur printer that was not purchased from CUR8 or a CUR8 guide has advised these settings need to be adjusted, there are hardware and software adjustments that are likely necessary for the printer to work correctly.
Boca Special Head Setting:
- You must update the Special Head setting in the printer itself.
- For instructions, use PDF titled "Special Print Head Settings," which is found at the bottom of this article
Boca Slide Bar Setting:
- To adjust the slide bar for CUR8 ticket stock, use the instructions on the PDF titled "Ticket Width," which can be found at the bottom of this article.
Once complete, your printer with CUR8 ticket stock installed should look like this:
Here are the instructions for installing a Boca Lemur printer.